Interface Range - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

interface range

interface range INTERFACE-ID [ , | - ]
Syntax Description
INTERFACE-ID
,
-
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface range eth2.1-2.5
Switch(config-if)#
CLI Reference Guide
Enter the interface range command to go into interface range configuration
mode. The command executed in this mode will be applied to all interfaces
specified by the command.
The interface can be physical port, port-channel, or IP interface.
Specifies a series of interface, or separate a range of interfaces from a previous
range. No space before and after the comma.
Specifies a range of interfaces. No space before and after the hyphen.
None
Global configuration
This command puts the command line interface into configuration mode for the
specified range of interfaces. The interfaces specified in a range can be different
types, such as eth2.1-2.5, vlan100-200.
This example shows how to enter the interface configuration mode for a range of
ports from eth2.1-2.5.
interface range
212