Mac Access-Group - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

mac access-group

M
mac access-group NAME [ in ]
no mac access-group NAME [ in ]
Syntax Description
NAME
in
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-if)# mac access-group daily-profile in
CLI Reference Guide
Use the mac access-group command to specify a MAC access list to be applied
to an interface. Use the no mac access-group command to remove the access
group control from the interface.
The name of the MAC access list to be applied. Up to 32 characters are allowed.
The syntax is a general string that does not allow spaces.
Specifies that the MAC access list will be applied in the ingress direction.
If the in direction is not specified, the default will be the in direction.
Interface configuration
Only one MAC access list can be applied to the same interface. An error
message is sent if an attempt is made to apply a second MAC access list and the
attempt is ignored.
The MAC access list must first be created using the mac access-list command
before it can be applied to interface. Otherwise, an error message will be
displayed.
The keyword in specifies the ingress direction check.
One MAC access-list, one IP access-list and one IPv6 access-list can be applied
to the same interface.
The association of an access-group with an interface will consume the filtering
entry resource in the switch controller. If the command is applied successfully,
the number of remaining max entries will be displayed. If the resource is
insufficient to commit the command, an error message will be displayed.
This example shows applied MAC access-list "daily-profile" to eth3.1
Verify the settings with the show access-group command.
mac access-group
399