Dot1X Control-Direction - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x control-direction

dot1x control-direction { both | in }
Syntax Description
both
in
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x control-direction in
CLI Reference Guide
Use this command to configure the direction of the traffic on a controlled port as
unidirectional (in) or bidirectional (both).
Enable bidirectional control. Both incoming and outgoing traffic through an
802.1X-enabled port are blocked if the port is not successfully authenticated.
Enable unidirectional control. Incoming traffic through an 802.1X-enabled port is
blocked if the port is not successfully authenticated.
both
Interface configuration
This command is only valid for physical port interface.
This command takes effect only when the global and per-port 802.1x enable
command is configured.
When the port is in force-unauthorized or un-authorized state, the traffic direction
is controlled based on this command.
When the port is in force-authorized or authorized state, the traffic is allowed in
both directions.
The following example shows how to specifies the direction of the traffic through
port eth4.1 as unidirectional.
Verify the settings by entering the show dot1x auth-configuration command.
dot1x control-direction
162