Gvrp Forbidden - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

gvrp forbidden

gvrp forbidden
no gvrp forbidden
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-if)# gvrp forbidden
CLI Reference Guide
Use the gvrp forbidden command to specify the port as a forbidden member.
Use the no gvrp forbidden command to remove the port as a forbidden
member.
None
None
Interface configuration
The physical port and port-channel interfaces are both valid for this command. If
a physical port is a member of a port-channel, entering the command returns an
error message. If multiple interfaces are specified, the command can be
executed partially. Error messages are sent if the interfaces fail to execute this
command.
When the gvrp forbidden command is configured, all VLANs will be forbidden
except the default VLAN (1) of this port.
If some VLANs have already been defined as allowable VLANs for the port, then
these VLAN memberships will be removed when issuing the gvrp forbidden
command. These memberships will not be recovered even when the no gvrp
forbidden command is applied.
This example shows how to set Ethernet eth3.1 as a GVRP forbidden port.
Verify the settings by entering the show gvrp configuration interface command
gvrp forbidden
204