Gvrp Advertise (Vlan) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

gvrp advertise (VLAN)

gvrp advertise
no gvrp advertise
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)# VLAN 1000
Switch(config-VLAN)# gvrp advertise
CLI Reference Guide
Use the gvrp advertise command to specify that this VLAN will be advertised
out by GVRP protocol. Use no gvrp advertise to disable this function.
None
Advertise is enabled
Config-VLAN configuration
If a VLAN has been configured to be advertised under the config-VLAN mode,
GVRP protocol will advertise this VLAN if it has any member ports. However the
command takes effect only in the running configuration, it is not stored in NV-
RAM for the next start up configuration. In the interface mode, the command is
stored in NV-RAM for next startup system configuration mode.
This example shows how to configure VLAN 1000 to be advertised.
Verify the settings by entering the show gvrp configuration command.
gvrp advertise (VLAN)
202