Vlan-Tunnel - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vlan-tunnel

vlan-tunnel
no vlan-tunnel
Syntax
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# vlan-tunnel
Switch(config)#
CLI Reference Guide
Use this command to enable the VLAN tunnel mode. Use the no form of the
command to disable the VLAN tunnel mode.
None
Disabled
Global configuration
This command enables VLAN tunneling mode. To turn VLAN tunneling mode
from disabled to enabled state. The default setting of VLAN tunneling mode is
applied with the following setting:
1. All interfaces are set as Network-to-Network Interfaces (NNI) port.
2. All existing static VLANs will run as SP-VLANs. All dynamically learned L2
addresses will be cleared.
3. All dynamically registered VLAN entries will be cleared.
4. IIn order to run GVRP on the switch, enable GVRP manually. In VLAN tunnel
mode, the SP-VLAN GVRP Address (01-80-C2-00-00-0D) will be used by the
GVRP protocol.
This example shows how to enable the VLAN tunnel mode.
Verify the settings by entering show vlan-tunnel command.
vlan-tunnel
904