DGS-6604
ip rip receive version
ip rip receive version VERSION-ID [ , | - ]
no ip rip receive version
Syntax Description
VERSION-ID
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip rip receive version 1-2
Switch(config-if)# end
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip rip receive version 1
Switch(config-if)# end
CLI Reference Guide
Use this command to specify a RIP version to receive on each interface. Use the
no form of the command to let the version follow the setting specified in the router
configuration mode.
The Version ID can be either 1 or 2. That is RIP accepts only RIP Version 1
packets on the interface or accepts only RIP Version 2 packets on the interface.
It also can be a list of version IDs such as 1,2 (or 1-2), meaning that both RIP
Version 1 and Version 2 packets are acceptable on the RIP enabled interface.
Global RIP version receive setting
Interface configuration
This command applies only to the interface being configured.
The following example shows how to configure interface (VLAN 1) to accept both
RIP Version 1 and Version 2 packets:
The following example shows how to configure the interface (VLAN 1) to only
accept RIP Version 1 packets:
Verify the settings by entering the show ip rip interface command.
ip rip receive version
306