D-Link DGS-6600-48T Cli Reference Manual page 713

DGS-6604 m
Example
Switch > enable
Switch # show ipv6 route
IPv6 Routing Table
Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF,
I - IS-IS, B - BGP
S ::/0 [1/0] via 192:0:7:2::2
C 20:50:71:1::/64 is directly connected, vlan10
O 115:50:70::/64 [110/2] via fe80::a00:1ff:fe02:6, vlan10, 0DT0H0M7S
O 150::/64 [110/20] via fe80::a00:1ff:fe02:6, vlan10, 0DT0H0M7S
C 192:0:7:2::/64 is directly connected, vlan111
S 192:0:123:2::/64 [1/0] via 20:50:71:1::2
[1/0] via 192:0:7:2::2
S 192:0:244:2::/64 [1/0] via 20:50:71:1::2
S a100::/64 [1/0] via fe80::250:baff:fe91:bb28, vlan111
[1/0] via fe80::a00:1ff:fe02:6, vlan10
Total Entries: 8 entries, 10 routes
Switch #
Switch > enable
Switch # show ipv6 route database
IPv6 Routing Table
Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF,
I - IS-IS, B - BGP
> - selected route, * - FIB route, p - stale info
S*> ::/0 [1/0] via 192:0:7:2::2
O 20:50:71:1::/64 [110/1] vlan10, 0DT0H8M36S
C*> 20:50:71:1::/64 is directly connected, vlan10
O*> 115:50:70::/64 [110/2] via fe80::a00:1ff:fe02:6, vlan10, 0DT0H1M5S
O*> 150::/64 [110/20] via fe80::a00:1ff:fe02:6, vlan10, 0DT0H1M5S
O 192:0:7:2::/64 [110/1] vlan111, 0DT0H8M36S
C*> 192:0:7:2::/64 is directly connected, vlan111
S*> 192:0:123:2::/64 [1/0] via 20:50:71:1::2
*>
S*> 192:0:244:2::/64 [1/0] via 20:50:71:1::2
S*> a100::/64 [1/0] via fe80::250:baff:fe91:bb28, vlan111
*> [1/0] via fe80::a00:1ff:fe02:6, vlan10
Total Entries: 10 entries, 12 routes
CLI Reference Guide
Use the show ipv6 route command to check what are the active routing entries
for IPv6 .
Use the show ipv6 route database command to check which routing database
entries for IPv6 are currently working.
[1/0] via 192:0:7:2::2
show ipv6 route
703