Ip Rip Send Version - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip rip send version

ip rip send version VERSION-ID [ , | - ]
no ip rip send version
Syntax Description
VERSION-ID
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip rip send version 1,2
Switch(config-if)# end
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip rip send version 2
Switch(config-if)# end
CLI Reference Guide
Use this command to specify a RIP version to send on an interface basis. Use
the no form of the command to let the version following the setting specified in
the router configuration mode.
The RIP Version ID can be either 1 or 2. That is, send out only RIP Version 1
packets on the interface or send out only RIP Version 2 packets on the RIP
enabled interface. It also can be a list of version IDs such as 1,2 (or 1-2)
meaning that both RIP Version 1 and Version 2 packets can be sent out from the
RIP enabled interface.
Global RIP version transmitt setting
Interface configuration
This command applies only to the interface being configured.
The following example shows how to configure the interface (VLAN 100) to send
both RIP Version 1 and Version 2 packets:
The following example shows how to configure the interface (VLAN 100) to send
only RIP Version 2 packets:
Verify the settings by entering the show ip rip interface command.
ip rip send version
307