Lldp Management-Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

lldp management-address

lldp management-address [ IP-ADDRESS | IPV6-ADDRESS ]
no lldp management-address [ IP-ADDRESS | IPV6-ADDRESS ]
Syntax Description
IP-ADDRESS
IPV6-ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch(config-if)# interface range eth3.1-3.2
Switch(config-if)# lldp management-address 10.1.1.1
CLI Reference Guide
To configure management address which will be advertised on the physical
interface, use the lldp management-address command. Use the no form of this
command to remove the settings.
(Optional) The IPv4 address which is carried in Management Address TLV.
(Optional) The IPv6 address which is carried in Management Address TLV.
When no IPv4 or IPv6 address is input for the command lldp management-
address, the swicth will find the least IP/IPv6 address if the smallest VLAN.
No LLDP management address is configured (no Management Address TLV is
sent)
Interface configuration
The command is available for physical port configuration. This command
specifies the IPv4/IPv6 address which is carried in Management Address TLV
on the specified port. If an IP address is specified, but the address is not one of
the addresses of system interfaces, then the address will not be sent.
When no optional address specified along the command lldp management
address, the switch will find least IP and IPv6 address of the VLAN with the
smallest VLAN ID, as default IP and IPv6 address respectively. If no applica-
ble IP/IPv6 address, no management address TLV will be advertised. Once
user configures an address (no matters what it is IP or IPv6 address), both of
the default IP and IPv6 management address become inactive and won't be
sen t. The default IP or IPv6 address will be active again when the configured
address is removed. Multiple IP/IPv6 management addresses can be config-
ured by setting this command multiple times.
Use the command no lldp management-address without specifying manage-
ment address to disable management address advertising in LLDPDUs.
If there is no management address in the list, no Management Address TLV
will be sent.
This example shows how to enable eth3.1 and eth3.2 for setting management
address entry (ipv4)
This example shows how to enable eth3.3 and eth3.4 for set management
address entry (ipv6)
lldp management-address
375