Show Ip Igmp Interface - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip igmp interface

show ip igmp interface [INTERFACE-ID [ , | - ] ]
Syntax Description
INTERFACE-ID [,|-]
,
-
Default
Command Mode
Usage Guideline
Example
Switch#show ip igmp interface vlan1000
vlan1000
IP Address/Netmask
IGMP State
Access Group
Version
Query Interval
Query Maximum Response Time
Robustness Value
Last Member Query Interval
Querier
Querier Timer countdown value
Configured Query Interval
Configured Maximum response time : 15
Configured Robustness
CLI Reference Guide
Used to display IGMP configuration information on interface
(Optional) Specifies a single interface, a range of interfaces separated by a
hyphen, or a series of interface separated by a comma. If no interface is
specified, the switch displays IGMP information for all interfaces where IGMP is
enabled (that is for all of IGMP enabled interfaces). Note, only a VLAN interface
type is allowed for this command.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from
a previous range. No space is allowed before and after the comma.
(Optional) Specifies a range of interfaces. No space is allowed before and after
the hyphen.
None
User EXEC or any configuration mode
User can display Interface IGMP configuration information by this command.
If the specified VLAN interface has IGMP disabled, all of the IGMP related
configuration shown as if IGMP is enabled with the exception that the IGMP state
is disabled. When no VLAN interface is specified, only IGMP enabled VLANs are
displayed for this command. While a VLAN interface list may incorporate IGMP
disabled VLANs, all of the listed VLAN's IGMP configuration information is
displayed.
This example shows how to display IGMP configure information about interface
VLAN 1000.
: 10.50.95.90/8
: Enabled
: igmp_fileter
: 3
: 125 seconds
: 10 seconds
: 2
: 1000 milliseconds
: 10.50.95.90
: -
: 5
: 2
show ip igmp interface
625