Boot Config - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

boot config

boot config [check] MEDIUM: URL
no boot config
Syntax Description
MEDIUM:URL
check
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to specify the file that will be used as the configuration file for
the next boot up.
Specifies the media where the file system is located.
The valid values are flash:\, cf1:\., etc. flash:\ represents system internal on-
board FLASH memory. cf1:\ represents the first (left) open slot compact FLASH
memory.
URL - Specifies the file to be assigned.
(Optional) This option is used for show the configuration file information for the
specified file. The information includes the file and model names.
Default configuration file is def_usr.conf
Global configuration
The boot config command specifes the file system and file name of the
configuration file to use for initialization (startup). The configuration file must be
an ASCII file located in the specified file system.
The command takes affect immediately and will be kept in NVRAM.
In the following situations the boot configuration does not update and an error
message is displayed:
• A configuration file is specified where the filename argument does not
exist or is not valid causing the boot configuration to not update and an
error message to be displayed.
• During initialization, the factory default configuration is used when the
boot config setting does not exist or when it is null (such as at a first-time
start-up). If the software detects a problem with the boot config file, the
device uses the factory default configuration for system boot up.
• When using the no form of this command, the boot configuration resets to
the default configuration
Use the show boot command to view the contents of the boot config
configuration file.
Initially, a system file is used as the factory default configuration.
boot config
79