ABB IRB 6650S Series Product Manual page 137

Table of Contents

Advertisement

Inspecting the oil level in axis-2 gearbox
Use this procedure to inspect the oil level in the axis-2 gearbox.
1
2
3
4
5
6
7
8
Product manual - IRB 6650S
3HAC020993-001 Revision: Z
Action
WARNING
Handling gearbox oil involves several safety
risks. Before proceeding, please read the safety
information in the section
work with gearbox lubricants (oil or grease) on
page
40.
DANGER
Turn off all:
electric power supply to the robot
hydraulic pressure supply to the robot
air pressure supply to the robot
Before entering the robot working area.
Make sure that the oil temperature is +25°C
±10°C.
Open the oil plug, filling and inspection.
Measure the oil level.
Required oil level: max. 5 mm below the inspec-
tion oil plug hole.
Adjust the oil level, if required.
Refit the oil plug.
WARNING
Do not mix oil types! If wrong oil is refilled, the
gearbox must be rinsed as detailed in Technical
reference manual - Lubrication in gearboxes.
© Copyright 2004-2018 ABB. All rights reserved.
3.3.3 Inspecting the oil level in axis-2 gearbox
Note
Safety risks during
This is a precaution to reduce the
temperature dependency of the
measurement.
Shown in the figure
box on page
xx1400002785
A Oil plug hole
B Required oil level
C Gearbox oil
Where to find type of oil and total
amount is detailed in
amount of oil in gearboxes on
page
Filling of oil is detailed further in the
section
Tightening torque: 24 Nm.
3 Maintenance
Continued
Location of gear-
136.
A
B
C
Type and
172.
Filling, oil on page
178.
137

Advertisement

Table of Contents
loading

Table of Contents