ABB IRB 6650S Series Product Manual page 301

8
Refitting, brake release board
Use this procedure to refit the brake release board.
1
2
3
4
Product manual - IRB 6650S
3HAC020993-001 Revision: Z
Action
Remove the brake release board from the
bracket by removing the four attachment
screws.
Action
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling
the unit read the safety information in section
The unit is sensitive to ESD on page 35
Connect the connectors X8, X9 and X10 to the
brake release board.
Be careful not to damage the sockets or pins.
Make sure the connector and its locking arms
are snapped down properly.
Fasten the brake release board on the bracket
with the attachment screws.
Make sure the board is pushed forwards and
positioned as straight as possible on the
bracket when fastening with the attachment
screws. The push buttons can otherwise get
jammed when the SMB cover is refitted.
xx1700001153
Refit the complete brake release board (includ-
ing brake release board and bracket) to the
SMB recess with the two attachment screws.
© Copyright 2004-2018 ABB. All rights reserved.
4.5.2 Replacing the brake release board
Note
Note
X8
X9
xx1700000978
Maximum tightening torque: 5 Nm.
Shown in the figure
release board on page
Art. no. is specified in
ment on page 299.
Continues on next page
4 Repair
Continued
X10
Location of brake
299.
Required equip-
301