Dhcp Snooping Configuration Commands - D-Link DWS-4000 Series Cli Command Reference

Example: The following shows example CLI display output for the command.
(DWS-4026) #show dhcp client vendor-id-option
DHCP Client Vendor Identifier Option is Enabled
DHCP Client Vendor Identifier Option string is D-LinkClient.
DHCP S
NOOPING
This section describes commands you use to configure DHCP Snooping.
ip dhcp snooping
Use this command to enable DHCP Snooping globally.
Default disabled
Format
ip dhcp snooping
Mode Global Config
no ip dhcp snooping
Use this command to disable DHCP Snooping globally.
Format
no ip dhcp snooping
Mode Global Config
ip dhcp snooping vlan
Use this command to enable DHCP Snooping on a list of comma-separated VLAN ranges.
Default disabled
Format
ip dhcp snooping vlan <vlan-list>
Mode Global Config
no ip dhcp snooping vlan
Use this command to disable DHCP Snooping on VLANs.
Format
no ip dhcp snooping vlan <vlan-list>
Mode Global Config
ip dhcp snooping verify mac-address
Use this command to enable verification of the source MAC address with the client hardware address in the received DCHP
message.
C
ONFIGURATION

DHCP Snooping Configuration Commands

C
OMMANDS
105