D-Link Unified Switch CLI Command Reference
no wids-security client threshold-value-probe
Use this command to set the threshold value for probe messages to the default.
Format
no wids-security client threshold-value-probe
Mode
Wireless Config
wids-security client threshold-interval-probe
Use this command to configure the threshold interval for counting the probe messages.
Default
60
Format
wids-security client threshold-interval-probe <1-3600>
Mode
Wireless Config
Parameter
Description
1-3600
The range of the threshold value.
no wids-security client threshold-interval-probe
Use this command to set the threshold value for the probe interval to its default.
Format
no wids-security client threshold-interval-probe
Mode
Wireless Config
wids-security client threshold-auth-failure
Use this command to configure the number of 802.1X authentication failures that triggers the client to be reported as rogue.
Default
5
Format
wids-security client threshold-auth-failure <1-99999>
Mode
Wireless Config
Parameter
Description
1-99999
The range of the threshold value.
no wids-security client threshold-auth-failure
Use this command to set the threshold value for authentication failures to its default.
Format
no wids-security client threshold-auth-failure
Mode
Wireless Config
© 2009 D-Link Corporation. All Rights Reserved
336