D-Link DWS-4000 Series Cli Command Reference page 286

D-Link Unified Switch CLI Command Reference
Format
show wireless ap profile <1-16> [radio <1-2> [[rates [{advertised |
supported}]] | channels]]
Mode Privileged EXEC
Parameter
Description
AP Profile ID AP profile ID.
Profile Name Descriptive name associated with the AP Profile ID.
Radio AP profile radio interface.
Status Indicates whether or not the radio is operational (on or off).
Mode Indicates the physical layer technology for the radio.
RF Scan - Other Indicates if the radio is configured to scan on channels other than its operating channel. A radio will
Channels Mode always scan on its operating channel.
RF Scan - Other If the radio is configured to scan other channels, indicates how often, in seconds, the radio will leave
Channels Interval its operating channel.
RF Scan - Sentry Indicates if the radio is configured for dedicated sentry scan mode. In this mode the radio does not
Mode allow any client associations.
RF Scan – Sentry Indicates which set of channels are scanned when sentry scan mode is enabled, for example, 802.11a
Scan Channels indicates the radio will scan all channels within the 802.11a frequency band (5 GHz).
RF Scan - Duration Indicates how long the radio will scan on one channel. This configuration applies to both scan other
channels mode and sentry scan mode.
Enable Broadcast/ Indicates if broadcast and multicast traffic rate limiting is enabled on the radio.
Multicast Rate
Limiting
Broadcast/ If rate limiting is enabled, broadcast/multicast traffic below this limit is transmitted normally.
Multicast Rate
Limit
Broadcast/ If rate limiting is enabled, broadcast/multicast traffic can occur in bursts up to this value before all traffic
Multicast Rate is considered to exceed the limit.
Limit Burst
Beacon Interval Interval at which the AP transmits beacon frames.
DTIM Period Indicates the number of beacons between DTIMs (Delivery Traffic Indication Map – indicates buffered
broadcast or multicast traffic on the AP).
Fragmentation Indicates the size limit for packets transmitted over the network. Packets under configured size are not
Threshold fragmented.
RTS Threshold Indicates the number of octets in an MPDU, below which an RTS/CTS handshake shall not be
performed.
Short Retry Limit Indicates the maximum number of transmission attempts on frame sizes less than or equal to the RTS
Threshold. This is a read-only value and cannot be configured.
Long Retry Limit Indicates the maximum number of transmission attempts on frame sizes greater than the RTS
Threshold. This is a read-only value and cannot be configured.
Maximum Transmit Indicates the elapsed time after the initial transmission of an MSDU, after which further attempts to
Lifetime transmit the MSDU shall be terminated. This is a read-only value and and cannot be configured.
Maximum Receive Indicates the elapsed time after the initial reception of a fragmented MMPDU or MSDU, after which
Lifetime further attempts to reassemble the MMPDU or MSDU shall be terminated. This is a read-only value
and cannot be configured.
Maximum Clients Maximum number of simultaneous associations allowed on the interface.
© 2009 D-Link Corporation. All Rights Reserved
278