D-Link Unified Switch CLI Command Reference
no isdp enable
This command disables ISDP on the interface.
Format
no isdp enable
Mode
Interface Config
clear isdp counters
This command clears ISDP counters.
Format
clear isdp counters
Mode
Privileged EXEC
clear isdp table
This command clears entries in the ISDP table.
Format
clear isdp table
Mode
Privileged EXEC
show isdp
This command displays global ISDP settings.
Format
show isdp
Mode
Privileged EXEC
Term
Definition
Timer
The frequency with which this device sends ISDP packets. This value is given in seconds.
Hold Time
The length of time the receiving device should save information sent by this device. This value is given
in seconds.
ISDPv2
The setting for sending ISDPv2 packets. If disabled, version 1 packets are transmitted.
Advertisements
Device ID
The Device ID advertised by this device. The format of this Device ID is characterized by the value of
the Device ID Format object.
Device ID Format
Indicates the Device ID format capability of the device.
Capability
• serialNumber indicates that the device uses a serial number as the format for its Device ID.
• macAddress indicates that the device uses a Layer 2 MAC address as the format for its Device ID.
• other indicates that the device uses its platform-specific format as the format for its Device ID.
Device ID Format
Indicates the Device ID format of the device.
• serialNumber indicates that the value is in the form of an ASCII string containing the device serial
number.
• macAddress indicates that the value is in the form of a Layer 2 MAC address.
• other indicates that the value is in the form of a platform specific ASCII string containing info that
identifies the device. For example, ASCII string contains serialNumber appended/prepended with
system name.
© 2009 D-Link Corporation. All Rights Reserved
158