Table of Contents
Advertisement
Maximum Routes................................. 6000
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled
show ip interface
This command displays all pertinent information about the IP interface.
Format
show ip interface <slot/port>
Modes
• Privileged EXEC
• User EXEC
Term
Definition
Routing Interface
Determine the operational status of IPv4 routing Interface. The possible values are Up or Down.
Status
Primary IP Address The primary IP address and subnet masks for the interface. This value appears only if you configure it.
Secondary IP
One or more secondary IP addresses and subnet masks for the interface. This value appears only if
Address
you configure it.
Helper IP Address The helper IP addresses configured by the
Routing Mode
The administrative mode of router interface participation. The possible values are enable or disable.
This value is configurable.
Administrative
The administrative mode of the specified interface. The possible values of this field are enable or
Mode
disable. This value is configurable.
Forward Net
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This value is
Directed
configurable.
Broadcasts
Proxy ARP
Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP
Displays whether Local Proxy ARP is enabled or disabled on the interface.
Active State
Displays whether the interface is active or inactive. An interface is considered active if its link is up and
it is in forwarding state.
Link Speed Data
An integer representing the physical link data rate of the specified interface. This is measured in
Rate
Megabits per second (Mbps).
MAC Address
The burned in physical address of the specified interface. The format is 6 two-digit hexadecimal
numbers that are separated by colons.
Encapsulation
The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
Type
IP MTU
The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth
Shows the bandwidth of the interface.
Destination
Displays whether ICMP Destination Unreachables may be sent (enabled or disabled).
Unreachables
ICMP Redirects
Displays whether ICMP Redirects may be sent (enabled or disabled).
Example: The following shows example CLI display output for the command.
(DWS-4026)#show ip interface 0/2
Routing Interface Status....................... Down
"ip helper-address"
command.
IP Routing Commands
173
Advertisement
Table of Contents
