Table 32: 802.1X Log Messages; Table 33: Igmp Snooping Log Messages - D-Link DWS-4000 Series Cli Command Reference

Component Message
Mac based VLANS vlanMacDeleteApply: Unable to delete an Entry
Mac based VLANS vlanMacVlanChangeCallback: Failed to add an
entry
Mac based VLANS vlanMacVlanChangeCallback: Failed to delete an
entry
Component Message
function : Failed calling dot1xIssueCmd
802.1X
802.1X function: EAP message not received from server RADIUS server did not send required EAP
802.1X function : Out of System buffers
802.1X function : could not set state to <authorized/
unauthorized>, intf xxx
802.1X dot1xApplyConfigData: Unable to <enable/
disable> dot1x in driver
802.1X dot1xSendRespToServer:
dot1xRadiusAccessRequestSend failed
802.1X dot1xRadiusAcceptProcess: error calling
radiusAccountingStart, ifIndex = xxx
function : failed sending terminate cause, intf xxx
802.1X
Component Message
IGMP Snooping function : osapiMessageSend failed
IGMP Snooping Failed to set global igmp snooping mode to xxx
IGMP Snooping Failed to set igmp snooping mode xxx for interface
yyy
IGMP Snooping Failed to set igmp mrouter mode xxx for interface
yyy
IGMP Snooping Failed to set igmp snooping mode xxx for vlan yyy Failed to set VLAN IGM Snooping mode due to
IGMP Snooping Failed to set igmp mrouter mode %d for interface
xxx on Vlan yyy
IGMP Snooping snoopCnfgrInitPhase1Process: Error allocating
small buffers
IGMP Snooping snoopCnfgrInitPhase1Process: Error allocating
large buffers
Table 31: MAC-based VLANs Log Messages (Cont.)

Table 32: 802.1x Log Messages

Table 33: IGMP Snooping Log Messages

Cause
This appears when a dtl fails to delete an entry
from the table.
This appears when a dtl fails to add an entry for a
vlan add notify event.
This appears when a dtl fails to delete an entry for
an vlan delete notify event.
Cause
802.1X message queue is full.
message.
802.1X cannot process/transmit message due to
lack of internal buffers.
DTL call failed setting authorization state of the
port.
DTL call failed enabling/disabling 802.1X.
Failed sending message to RADIUS server.
Failed sending accounting start to RADIUS server.
Failed sending accounting stop to RADIUS server.
Cause
IGMP Snooping message queue is full.
Failed to set global IGMP Snooping mode due to
message queue being full.
Failed to set interface IGMP Snooping mode due
to message queue being full.
Failed to set interface multicast router mode due to
IGMP Snooping message queue being full.
message queue being full.
Failed to set VLAN multicast router mode due to
IGMP Snooping message queue being full.
Could not allocate buffers for small IGMP packets.
Could not allocate buffers for large IGMP packets.
Switching
529