Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
Format
no wpa2 pre-authentication
Mode
Network Config
wpa2 pre-authentication limit
This command configures the WPA2 pre-authentication limit for the network. This specifies a limit on the number of APs
within the peer group to which one client is allowed to pre-authenticate.
Default
0, no limit
Format
wpa2 pre-authentication limit <0-192>
Mode
Network Config
Parameter
Description
0-192
Valid WPA2 pre-authentication limit.
no wpa2 pre-authentication limit
The no version of this command sets the configured WPA2 pre-authentication limit to its default value.
Format
no wpa2 pre-authentication limit
Mode
Network Config
wpa2 key-forwarding
This command enables WPA2 key forwarding support for client roaming on the network.
Default
Enable
Format
wpa2 key-forwarding
Mode
Network Config
no wpa2 key-forwarding
The no version of this command disables WPA2 key forwarding support on the network.
Format
no wpa2 key-forwarding
Mode
Network Config
wpa2 key-caching holdtime
This command configures the length of time a PMK will be cached by an AP for either client roaming or key forwarding.
Default
10
Format
wpa2 key-caching holdtime <0-1440>
Mode
Network Config
© 2009 D-Link Corporation. All Rights Reserved
256
Advertisement
Table of Contents
