Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
show ip route summary
Use this command to display the routing table summary. Use the optional all parameter to show the number of all routes,
including best and non-best routes. To include only the number of best routes, do not use the optional parameter.
Format
show ip route summary [all]
Modes
• Privileged EXEC
• User EXEC
Term
Definition
Connected Routes The total number of connected routes in the routing table.
Static Routes
Total number of static routes in the routing table.
RIP Routes
Total number of routes installed by RIP protocol.
Reject Routes
Total number of reject routes installed by all protocols.
Total Routes
Total number of routes in the routing table.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show ip route summary
Connected Routes..............................1
Static Routes.................................7
RIP Routes....................................0
Reject Routes.................................2
Total routes..................................8
show ip route preferences
This command displays detailed information about the route preferences. Route preferences are used in determining the
best route. Lower router preference values are preferred over higher router preference values. A route with a preference of
255 cannot be used to forward traffic.
Format
show ip route preferences
Modes
• Privileged EXEC
• User EXEC
Term
Definition
Local
The local route preference value.
Static
The static route preference value.
RIP
The RIP route preference value.
show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more information about the fields that are displayed.
© 2009 D-Link Corporation. All Rights Reserved
176
Advertisement
Table of Contents
