D-Link DWS-4000 Series Cli Command Reference page 468

D-Link Unified Switch CLI Command Reference
no debug ip acl
Use this command to disable debug of IP Protocol packets matching the ACL criteria.
Format
no debug ip acl <acl Number>
Mode Privileged EXEC
debug ip vrrp
Use this command to enable VRRP debug protocol messages.
Default disabled
Format
debug ip vrrp
Mode Privileged EXEC
no debug ip vrrp
Use this command to disable VRRP debug protocol messages.
Format
no debug ip vrrp
Mode Privileged EXEC
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
Default disabled
Format
debug lacp packet
Mode Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
Format
no debug lacp packet
Mode Privileged EXEC
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. receive traces only received MLD snooping
packets and transmit traces only transmitted MLD snooping packets. When neither keyword is used in the command, then
all MLD snooping packet traces are dumped. Vital information such as source address, destination address, control packet
type, packet length, and the interface on which the packet is received or transmitted is displayed on the console.
© 2009 D-Link Corporation. All Rights Reserved
460