Telnet Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
T C
ELNET OMMANDS
This section describes the commands you use to configure and view Telnet settings. You can use Telnet to manage the
device from a remote management host.
ip telnet server enable
Use this command to enable Telnet connections to the system and to enable the Telnet Server Admin Mode. This command
opens the Telnet listening port.
Default enabled
Format
ip telnet server enable
Mode Privileged EXEC
no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet Server Admin Mode. This command
closes the Telnet listening port and disconnects all open Telnet sessions.
Format
no ip telnet server enable
Mode Privileged EXEC
telnet
This command establishes a new outbound Telnet connection to a remote host. The host value must be a valid IP address
or host name. Valid values for port should be a valid decimal integer in the range of 0 to 65535, where the default value is
23. If [debug] is used, the current Telnet options enabled is displayed. The optional line parameter sets the outbound Telnet
operational mode as linemode where, by default, the operational mode is character mode. The noecho option disables local
echo.
Format
telnet <ip-address|hostname> <port> [debug] [line] [noecho]
Modes • Privileged EXEC
• User EXEC
transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established until there are no more
sessions available. An established session remains active until the session is ended or an abnormal network error ends the
session.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established. Use the ip telnet
server enable command to enable Telnet Server Admin Mode.
Default enabled
Format
transport input telnet
Mode Line Config
© 2009 D-Link Corporation. All Rights Reserved
478