Table of Contents
Advertisement
seconds. The <hold-value> is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The
multiplier range is 2-10. The <reinit-seconds> is the delay before re-initialization, and the range is 1-0 seconds.
Default
• interval—30 seconds
• hold—4
• reinit—2 seconds
Format
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-
seconds>
Mode
Global Config
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to the default
values.
Format
no lldp timers [interval] [hold] [reinit]
Mode
Global Config
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are transmitted
in the LLDPDUs. Use sys-name to transmit the system name TLV. To configure the system name, see
page
496. Use sys-descto transmit the system description TLV. Use sys-cap to transmit the system capabilities TLV. Use
port-desc to transmit the port description TLV. To configure the port description, see See "description" on page 15.
Default
no optional TLVs are included
Format
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
Interface Config
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without parameters to remove all
optional TLVs from the LLDPDU.
Format
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
Interface Config
lldp transmit-mgmt
Use this command to include transmission of the local system management address information in the LLDPDUs.
Format
lldp transmit-mgmt
Mode
Interface Config
]
LLDP (802.1AB) Commands
"snmp-server" on
133
Advertisement
Table of Contents
