Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode
Global Config
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the IP ACL.
Format
show ip access-lists <accesslistnumber>
Mode
Privileged EXEC
Note: Only the access list fields that you configure are displayed.
Term
Definition
Rule Number
The number identifier for each rule that is defined for the IP ACL.
Action
The action associated with each rule. The possible values are Permit or Deny.
Match All
Indicates whether this access list applies to every packet. Possible values are True or False.
Protocol
The protocol to filter for this rule.
Source IP Address The source IP address for this rule.
Source IP Mask
The source IP Mask for this rule.
Source L4 Port
The source port for this rule.
Keyword
Destination IP
The destination IP address for this rule.
Address
Destination IP
The destination IP Mask for this rule.
Mask
Destination L4 Port
The destination port for this rule.
Keyword
IP DSCP
The value specified for IP DSCP.
IP Precedence
The value specified IP Precedence.
IP TOS
The value specified for IP TOS.
Log
Displays when you enable logging for the rule.
Assign Queue
The queue identifier to which packets matching this rule are assigned.
Mirror Interface
The slot/port to which packets matching this rule are copied.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show ip access-lists 2
ACL ID: 2
Rule Number: 1
Action......................................... permit
© 2009 D-Link Corporation. All Rights Reserved
404
Advertisement
Table of Contents
