D-Link DWS-4000 Series Cli Command Reference page 270

D-Link Unified Switch CLI Command Reference
Parameter Description
name AP Profile name; it must be less than 32 characters. Use quotes around a name that contains spaces.
no name
The no version of this command deletes the configured name for the AP profile.
Format
no name
Mode AP Profile Config
hwtype
This command allows you to configure the AP hardware type. Currently, only the hw_dwl8600 hardware type is supported.
Default hw_dwl8600
Format
hwtype <hw_dwl8600>
Mode AP Profile Config
Parameter Description
hw_dwl8600 AP hardware type.
no hwtype
This command allows you to set the AP hardware type to the default value "hw_dwl8600".
Format
no hwtype
Mode AP Profile Config
Example: The following shows an example of the command.
DWS-4026 (Config-ap-profile)#
<cr> Press Enter to execute the command.
vlan (AP Profile Config Mode)
This command allows you to configure the VLAN ID used to send tracer packets by wired network detection algorithm. If
VLAN is "0", the tracer packets will be sent untagged.
Default 1
Format
vlan <0-4094>
Mode AP Profile Config
Parameter Description
0-4094 Wired network detection VLAN ID.
© 2009 D-Link Corporation. All Rights Reserved
262
no hwtype ?