D-Link DWS-4000 Series Cli Command Reference page 25

show port
This command displays port information.
Format
show port {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Type If not blank, this field indicates that this port is a special type of port. The possible values are:
• Mirror - this port is a monitoring port. For more information, see
• PC Mbr- this port is a member of a port-channel (LAG).
• Probe - this port is a probe port.
Admin Mode The Port control administration state. The port must be enabled in order for it to be allowed into the
network. - May be enabled or disabled. The factory default is enabled.
Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex
mode and speed is set from the auto-negotiation process. Note that the maximum capability of the port
(full duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.
Link Trap This object determines whether or not to send a trap when link status changes. The factory default is
enabled.
LACP Mode LACP is enabled or disabled on this port.
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group.
Format
show port protocol {<groupid> | all}
Mode Privileged EXEC
Term Definition
Group Name The group name of an entry in the Protocol-based VLAN table.
Group ID The group identifier of the protocol group.
Protocol(s) The type of protocol(s) for this group.
VLAN The VLAN associated with this Protocol Group.
Interface(s) Lists the slot/port interface(s) that are associated with this Protocol Group.
Port Configuration Commands
"Port Mirroring" on page 94.
17