Routing Information Protocol Commands - D-Link DWS-4000 Series Cli Command Reference

Hide thumbs Also See for DWS-4000 Series:

Table of Contents

D-Link Unified Switch CLI Command Reference

no ip helper-address

Use this command to remove the IP address from the previously configured list. The no command without an <

> argument removes the entire list of helper addresses on that interface.

no ip helper-address <ip-address>

Interface Config

show ip helper-address

Use this command to display the configured helper addresses on the given interface.

show ip helper-address <interface>

• Privileged EXEC

Example: The following shows example CLI display output for the command.

(DWS-4026) #show ip helper-address 0/1

Helper IP Address.............................. 1.2.3.4

............................................... 1.2.3.5

This section describes the commands you use to view and configure Routing Information Protocol (RIP), which is a distance-

vector routing protocol that you use to route traffic within a small network.

Use this command to enter Router RIP mode.

Global Config

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).

Router RIP Config