D-Link DWS-4000 Series Cli Command Reference page 341

Format
no wids-security client configured-deauth-rate
Mode Wireless Config
wids-security client max-auth-failure
Use this command to enable the test which marks the client as rogue if it exceeds the maximum number of authentication
failures.
Default Enable
Format
wids-security client max-auth-failure
Mode Wireless Config
no wids-security client max-auth-failure
Use this command to disable the test for checking if the client has exceeded the configured rate for maximum authentication
failures.
Format
no wids-security client max-auth-failure
Mode Wireless Config
wids-security client auth-with-unknown-ap
Use this command to enable the test to check if a known client is authenticated with an unknown AP. If yes, then the client
is marked as a rogue.
Default Enable
Format
wids-security client auth-with-unknown-ap
Mode Wireless Config
no wids-security client auth-with-unknown-ap
Use this command to disable the test for checking if the client is authenticated with an unknown AP.
Format
no wids-security client auth-with-unknown-ap
Mode Wireless Config
wids-security client threat-mitigation
Use this command to enable the transmission of de-authentication messages to known clients associated with unknown
APs. The "Known Client" test must also be enabled order for the mitigation to take place.
Default Disable
Format
wids-security client threat-mitigation
Mode Wireless Config
Detected Clients Database Commands
333