D-Link DWS-4000 Series Cli Command Reference page 202

D-Link Unified Switch CLI Command Reference
version 2 formatted packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP
control packets to be sent.
Default ripi2
Format
ip rip send version {rip1 | rip1c | rip2 | none}
Mode Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be sent.
Format
no ip rip send version
Mode Interface Config
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default enabled
Format
hostroutesaccept
Mode Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
no hostroutesaccept
Mode Router RIP Config
split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding problems caused by including routes
in updates sent to the router from which the route was originally learned. The options are: None - no special processing for
this case. Simple - a route will not be included in updates sent to the router from which it was learned. Poisoned reverse - a
route will be included in updates sent to the router from which it was learned, but the metric will be set to infinity.
Default simple
Format
split-horizon {none | simple | poison}
Mode Router RIP Config
no split-horizon
This command sets the default RIP split horizon mode.
Format
no split-horizon
Mode Router RIP Config
© 2009 D-Link Corporation. All Rights Reserved
194