Secure Shell Commands - D-Link DWS-4000 Series Cli Command Reference

show telnet
This command displays the current outbound Telnet settings. In other words, these settings apply to Telnet connections
initiated from the switch to a remote system.
Format
show telnet
Modes • Privileged EXEC
• User EXEC
Term Definition
Outbound Telnet The number of minutes an outbound Telnet session is allowed to remain inactive before being logged
Login Timeout off.
Maximum Number The number of simultaneous outbound Telnet connections allowed.
of Outbound Telnet
Sessions
Allow New Indicates whether outbound Telnet sessions will be allowed.
Outbound Telnet
Sessions
show telnetcon
This command displays the current inbound Telnet settings. In other words, these settings apply to Telnet connections
initiated from a remote system to the switch.
Format
show telnetcon
Modes • Privileged EXEC
• User EXEC
Term Definition
Remote This object indicates the number of minutes a remote connection session is allowed to remain inactive
Connection Login before being logged off. May be specified as a number from 1 to 160. The factory default is 5.
Timeout (minutes)
Maximum Number This object indicates the number of simultaneous remote connection sessions allowed. The factory
of Remote default is 5.
Connection
Sessions
Allow New Telnet New Telnet sessions will not be allowed when this field is set to no. The factory default value is yes.
Sessions
S S
ECURE HELL
This section describes the commands you use to configure Secure Shell (SSH) access to the switch. Use SSH to access
the switch from a remote management host.
Note: The system allows a maximum of 5 SSH sessions.
C
OMMANDS

Secure Shell Commands

481