Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
in the following format:
(DWS-4026) #show wireless client summary
MAC Address
------------------ ----------------- -----------------
00:0F:B5:86:93:95 8.0.1.29
00:0F:B5:86:93:96 8.0.1.29
show wireless client client-qos status
This command displays detailed client QoS data for clients associated to a managed AP. These are the current operational
values in effect for the specified client.
Format
show wireless client <macaddr> client-qos status
Mode
Privileged EXEC
Field
Description
macaddr
Client MAC address.
MAC Address
The Ethernet address of the client station.
SSID
The network on which the client is connected.
Client QoS
Indicates whether or not the client is performing client QoS operations. Possible values are Enabled
Operational Status
or Disabled.
Bandwidth Limit
The maximum transmission rate limit in bits per second in effect for traffic flowing from the AP to the
Down
client. This may differ from the configured value due to rounding. A value of 0 indicates no rate limiting
is in effect in this direction.
Bandwidth Limit
The maximum transmission rate limit in bits per second in effect for traffic flowing from the client to the
Up
AP. This may differ from the configured value due to rounding. A value of 0 indicates no rate limiting is
in effect in this direction.
Access Control
Identifies the access control list in effect for traffic flowing from the AP to the client. Both the ACL type
Down
and its name (or number) is displayed. A value of <none> indicates no access control is in effect in
this direction.
Access Control Up Identifies the access control list in effect for traffic flowing from the client to the AP. Both the ACL type
and its name (or number) is displayed. A value of <none> indicates no access control is in effect in
this direction.
Diffserv Policy
Identifies the Diffserv policy in effect for traffic flowing from the AP to the client. A value of <none>
Down
indicates no policy is in effect in this direction.
Diffserv Policy Up Identifies the Diffserv policy in effect for traffic flowing from the client to the AP. A value of <none>
indicates no policy is in effect in this direction.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show wireless client 00:0F:B5:86:93:95 client-qos status
MAC Address.................................... 00:0F:B5:86:93:95
SSID........................................... l7network
Client QoS Operational Status.................. Disabled
Bandwidth Limit Down........................... 0
Bandwidth Limit Up............................. 0
Access Control Down............................ <none>
Access Control Up.............................. <none>
Diffserv Policy Down........................... <none>
© 2009 D-Link Corporation. All Rights Reserved
314
IP Address
NetBIOS Name
l7client-01
l7client-02
Advertisement
Table of Contents
