D-Link DWS-4000 Series Cli Command Reference page 490

D-Link Unified Switch CLI Command Reference
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the ip ssh server enable
command.)
Default disabled
Format
ip ssh
Mode Privileged EXEC
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2), or both SSH 1 and
SSH 2 (1 and 2) can be set.
Default 1 and 2
Format
ip ssh protocol [1] [2]
Mode Privileged EXEC
ip ssh server enable
This command enables the IP secure shell server.
Default disabled
Format
ip ssh server enable
Mode Privileged EXEC
no ip ssh server enable
This command disables the IP secure shell server.
Format
no ip ssh server enable
Mode Privileged EXEC
sshcon maxsessions
This command specifies the maximum number of SSH connection sessions that can be established. A value of 0 indicates
that no ssh connection can be established. The range is 0 to 5.
Default 5
Format
sshcon maxsessions <0-5>
Mode Privileged EXEC
no sshcon maxsessions
This command sets the maximum number of allowed SSH connection sessions to the default value.
Format
no sshcon maxsessions
Mode Privileged EXEC
© 2009 D-Link Corporation. All Rights Reserved
482