D-Link DWS-4000 Series Cli Command Reference page 472

D-Link Unified Switch CLI Command Reference
Parameter Definition
Source_Mac Source MAC address of the packet.
Version Spanning tree protocol version (0-3). 0 refers to STP, 2 RSTP and 3 MSTP.
Root_Mac MAC address of the CIST root bridge.
Root_Priority Priority of the CIST root bridge. The value is between 0 and 61440. It is displayed in hex in multiples
of 4096.
Path_Cost External root path cost component of the BPDU.
no debug spanning-tree bpdu receive
This command disables tracing of received spanning tree BPDUs.
Format
no debug spanning-tree bpdu receive
Mode Privileged EXEC
debug spanning-tree bpdu transmit
This command enables tracing of spanning tree BPDUs transmitted by the switch. Spanning tree should be enabled on the
device and on the interface in order to monitor packets on a particular interface.
Default disabled
Format
debug spanning-tree bpdu transmit
Mode Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 01:02:04 192.168.17.29-1 DOT1S[191096896]: dot1s_debug.c(1249) 101 % Pkt TX -
Intf: 0/7(7), Source_Mac: 00:11:88:4e:c2:00 Version: 3, Root_Mac: 00:11:88:4e:c2:00,
Root_Priority: 0x8000 Path_Cost: 0
The following parameters are displayed in the trace message:
Parameter Definition
TX A packet transmitted by the device.
Intf The interface that the packet went out on. Format used is unit/port/slot (internal interface number). Unit
is always shown as 1.
Source_Mac Source MAC address of the packet.
Version Spanning tree protocol version (0-3). 0 refers to STP, 2 RSTP and 3 MSTP.
Root_Mac MAC address of the CIST root bridge.
Root_Priority Priority of the CIST root bridge. The value is between 0 and 61440. It is displayed in hex in multiples
of 4096.
Path_Cost External root path cost component of the BPDU.
© 2009 D-Link Corporation. All Rights Reserved
464