Autoinstall Commands - D-Link DWS-4000 Series Cli Command Reference

A I C
UTO NSTALL
The AutoInstall feature enables the automatic configuration of a switch when the device is initialized and no configuration
file is found on the switch. When no configuration file is found, it is downloaded from a TFTP server and saved to non-volatile
memory. The TFTP server name or address is provided by a DHCP server in response to a IP address request initiated
during startup.
boot autoinstall
The command enables/disables autoinstall on the switch.
Default
enable
Format
boot autoinstall {start | stop}
Mode Privileged EXEC
boot autoinstall auto-save
This command enables or disables saving the network configuration to non-volatile memory. When enabled, the
configuration is saved after downloading from the TFTP server without operator intervention. When disabled, the operator
must explicitly save the configuration, if needed.
Default
enable
Format
boot autoinstall auto-save
Mode Privileged EXEC
no boot autoinstall auto-save
This command disables saving the network configuration to non-volatile memory.
boot autoinstall retry-count
This command sets the number of unicast TFTP attempts for the configuration file.
Default
3
Format
boot autoinstall retry-count <1-6>
Mode Privileged EXEC
no boot autoinstall retry-count
This command sets to the default the number of unicast TFTP attempts for the configuration file.
Format
no boot autoinstall retry-count
Mode Privileged EXEC
OMMANDS

AutoInstall Commands

471