D-Link DWS-4000 Series Cli Command Reference page 276

D-Link Unified Switch CLI Command Reference
Default • Disabled
• Channels, all
Format
rf-scan sentry [channels {a | bg | all}]
Mode AP Profile Radio Config
Parameter Description
channels Indicates to scan channels within specified mode/frequency.
a Perform RF scan on all 802.11a channels (5 GHz frequency).
bg Perform RF scan on all 802.11b/g channels (2.4 GHz frequency).
all Perform RF scan on all channels.
no rf-scan sentry
The no version of this command disables dedicated scanning and enables normal operation of the radio.
Format
no rf-scan sentry
Mode AP Profile Radio Config
rf-scan duration
This command configures the RF scan duration for the radio. The duration indicates how long the radio will scan on one
channel.
Default 10 milliseconds
Format
rf-scan duration <10-2000>
Mode AP Profile Radio Config
Parameter Description
10-2000 Time duration in milliseconds.
no rf-scan duration
The no version of this command returns the configured RF scan duration to its default value.
Format
no rf-scan duration
Mode AP Profile Radio Config
station-isolation
This command enables the Station Isolation mode on the radio. When Station Isolation is enabled, the access point blocks
communication between wireless clients. The access point still allows data traffic between its wireless clients and wired
devices on the network, but not among wireless clients.
© 2009 D-Link Corporation. All Rights Reserved
268