D-Link DWS-4000 Series Cli Command Reference page 91

lacp actor admin state longtimeout
Use this command to set LACP actor admin state to longtimeout.
Format
lacp actor admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Format
no lacp actor admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
Format
lacp actor admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format
no lacp actor admin state passive
Mode Interface Config
lacp actor port
Use this command to configure LACP actor port priority key.
lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid range for <priority> is 0 to
255.
Default 0x80
Format
lacp actor port priority <priority>
Mode Interface Config
Port-Channel/LAG (802.3ad) Commands
83