Table of Contents
Advertisement
Format
no peer-switch configuration [{ap-database|ap-profile|captive-portal| channel-
power|discovery|global|known-client|radius-client}]
Mode
Wireless Config
wireless peer-switch configure
This command allows the administrator to initiate a configuration push to one or all peer switches. If no parameters are given,
all peer switches are configured. If the optional IP address parameter is specified, only that peer switch is configured.
Format
wireless peer-switch configure [<ipaddr>]
Mode
Privileged EXEC
Parameter
Description
ipaddr
Peer switch IP address.
client roam-timeout
This command configures maximum duration for which a client entry is retained in the client association database after
disassociating from a managed AP. Roam-timeout is the time in seconds after disassociation for the entry to be deleted from
the managed AP client association database.
Default
30 seconds
Format
client roam-timeout <1-120>
Mode
Wireless Config
Parameter
Description
roam-timeout
Time in seconds after disassociation for the entry to be deleted from the managed AP client association
database.
1-120
Time in seconds from 1 to 120.
no client roam-timeout
The no version of this command returns the configured client age timeout to the default.
Format
no client roam-timeout
Mode
Wireless Config
tunnel-mtu
This command configures the network MTU size for all access points. This configuration is only used for tunneled networks
and is, therefore, only available if the wireless tunneling feature is enabled. Note that the physical ports on the Unified Switch
and the rest of the network devices must also be configured with the appropriate MTU size. This configuration applies only
to the managed access points.
Unified Switch Commands
207
Advertisement
Table of Contents
