D-Link DWS-4000 Series Cli Command Reference page 356

D-Link Unified Switch CLI Command Reference
no trapflags
This command disables all captive portal SNMP traps when no parameters are specified. The optional parameters specify
individual traps to disable.
Format
no trapflags [{client-auth-failure | client-connect |
client-db-full | client-disconnect}]
Mode Captive Portal Config
authentication timeout
This command configures the authentication timeout. If the captive portal user does not enter valid credentials within this
time limit, the authentication page needs to be served again in order for the client to gain access to the network. The
<timeout> variable is the authentication timeout and is a number in the range of 60-600 seconds.
Default 300
Format
authentication timeout <timeout>
Mode Captive Portal Config
no authentication timeout
This command sets the authentication timeout to the default value.
Format
no authentication timeout
Mode Captive Portal Config
show captive-portal
This command reports status of the captive portal feature.
Format
show captive-portal
Mode Privileged EXEC
Field Description
Administrative Shows whether the CP is enabled.
Mode
Operational Status Indicates whether the CP operational status is enabled or disabled.
Disable Reason If CP is disabled, this field displays the reason, which can be None, Administratively Disabled, No IPv4
Address, or Routing Enabled, but no IPv4 routing interface.
Captive Portal IP Shows the IP address that the captive portal feature uses.
Address
show captive-portal status
This command reports status of all captive portal instances in the system.
© 2009 D-Link Corporation. All Rights Reserved
348