O/S Support; Table 52: Osapi Vxworks Log Messages - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Component Message
Driver USL: failed to sync initiator table on unit = x
Driver USL: failed to sync terminator table on unit = x
Driver USL: failed to sync ip-multicast table on unit = x
O/S S
UPPORT
Component Message
OSAPI VxWorks ftruncate failed – File resides on a read-only file
system.
OSAPI VxWorks ftruncate failed – File is open for reading only.
OSAPI VxWorks ftruncate failed – File descriptor refers to a file on
which this operation is impossible.
OSAPI VxWorks ftruncate failed – Returned an unknown code in
errno.
OSAPI VxWorks ping: bad host!
OSAPI VxWorks osapiTaskDelete: Failed for (XX) error YYY
OSAPI VxWorks osapiCleanupIf: NetIPGet
OSAPI VxWorks osapiCleanupIf: NetMaskGet
OSAPI VxWorks osapiCleanupIf: NetIpDel
OSAPI VxWorks osapiSemaTake failed
© 2009 D-Link Corporation. All Rights Reserved
536
Table 51: Driver Error Messages (Cont.)

Table 52: OSAPI VxWorks Log Messages

Cause
Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Cause
ftruncate is called to correctly set the file's size in
the file system after a write. The file system is R/W
so this msg indicates the file system may be
corrupted.
ftruncate is called to correctly set the file's size in
the file system after a write. The file is opened for
R/W so this msg indicates the file system may be
corrupted.
ftruncate is called to correctly set the file's size in
the file system after a write. This msg indicates the
file system may be corrupted.
ftruncate is called to correctly set the file's size in
the file system after a write. This msg indicates the
file system may be corrupted.
The address requested to ping can not be
converted to an Internet address.
The requested task can not be deleted because:
the requested deletion is called from an ISR, the
task is already deleted, or the task ID is invalid.
During the call to remove the interface from the
route table, the attempt to get an ipv4 interface
address from the stack failed.
During the call to remove the interface from the
route table ,the attempt to get the ipv4 interface
mask from the stack failed.
During the call to remove the interface from the
route table, the attempt to delete the primary ipv4
address from the stack failed.
The requested semaphore can not be taken
because: the call is made from an ISR or the
semaphore ID is invalid.