D-Link DWS-4000 Series Cli Command Reference page 65

Format
no dot1x max-req
Mode Interface Config
dot1x max-users
Use this command to set the maximum number of clients supported on the port when MAC-based dot1x authentication is
enabled on the port. The maximum users supported per port is dependent on the product. The <count> value is in the range
1 - 16.
Default 16
Format
dot1x max-users <count>
Mode Interface Config
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Format
no dot1x max-req
Mode Interface Config
dot1x port-control
This command sets the authentication mode to use on the specified port. Select force-unauthorized to specify that the
authenticator PAE unconditionally sets the controlled port to unauthorized. Select force-authorized to specify that the
authenticator PAE unconditionally sets the controlled port to authorized. Select auto to specify that the authenticator PAE
sets the controlled port mode to reflect the outcome of the authentication exchanges between the supplicant, authenticator
and the authentication server. If the
the port.
Note: MAC-based dot1x authentication is supported on the BCM56224, BCM56514, BCM56624, and BCM56820
platforms.
Default auto
Format
dot1x port-control {force-unauthorized | force-authorized | auto | mac-based}
Mode Interface Config
no dot1x port-control
This command sets the 802.1x port control mode on the specified port to the default value.
Format
no dot1x port-control
Mode Interface Config
dot1x port-control all
This command sets the authentication mode to use on all ports. Select force-unauthorized to specify that the
authenticator PAE unconditionally sets the controlled port to unauthorized. Select force-authorized to specify that the
mac-based option is specified, then MAC-based dot1x authentication is enabled on
Port-Based Network Access Control Commands
57