D-Link DWS-4000 Series Cli Command Reference page 200

D-Link Unified Switch CLI Command Reference
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode Router RIP Config
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
no default-metric
Mode Router RIP Config
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values are preferred when
determining the best route. A route with a preference of 255 cannot be used to forward traffic.
Default 15
Format
distance rip <1-255>
Mode Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode Router RIP Config
distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source protocol.
Default 0
Format
distribute-list <1-199> out {static | connected}
Mode Router RIP Config
© 2009 D-Link Corporation. All Rights Reserved
192