D-Link DWS-4000 Series Cli Command Reference page 335

Format
no wids-security wired-detection-interval
Mode Wireless Config
show wireless wids-security
This command displays the configured wireless WIDS security settings.
Format
show wireless wids-security
Mode Privileged EXEC
Field Description
Rogue - admin If the local database indicates that the AP is rogue, then reports the AP as rogue in the RF Scan.
configured Rogue
APs
Rogue - APs on an Enable or disable rogue reporting for APs operating on an illegal channel.
illegal channel
Rogue - fake Enable or disable rogue reporting for fake managed APs on an invalid channel.
managed AP/
invalid channel
Rogue - fake Enable or disable rogue reporting for fake managed APs without an SSID.
managed AP/no
SSID
Rogue - managed Enable or disable rogue reporting for a managed AP with an invalid SSID.
AP/invalid SSID
Rogue - managed Enable or disable rogue reporting for APs with a managed SSID and an incorrect security
SSID/invalid configuration.
security
Rogue - standalone Enable or disable rogue reporting for standalone APs operating with unexpected channel, security, or
AP/unexpected WIDS mode.
config
Rogue - unknown Enable or disable rogue reporting for unknown rogue APs detected with a managed SSID.
AP/managed SSID
Rogue - Enable or disable rogue reporting for unmanaged APs on a wired network.
unmanaged AP on
a wired network
Rogue - Enable or disable rogue reporting for unexpected WDS devices detected on the network.
unexpected WDS
devices
Rogue detected The interval in seconds between transmissions of the trap telling the administrator that rogues are
trap interval present in the RF Scan database.
Wired network Minimum number of seconds that the AP waits before starting a new wired network detection cycle.
detection interval
AP De- Enable or disable the AP De-authentication attack.
authentication
Attack
Example: The following shows example CLI display output for the command.
(DWS-4026) # show wireless wids-security
WIDS Access Point RF Security Commands
327