D-Link Unified Switch CLI Command Reference
Component
Message
GARP/GVRP/
garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
GMRP
garpApiCnfgrCommand,
garpLeaveAllTimerCallback, garpTimerCallback:
QUEUE SEND FAILURE:
GARP/GVRP/
GarpSendPDU: QUEUE SEND FAILURE
GMRP
GARP/GVRP/
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GMRP
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
GARP/GVRP/
garpTraceMsgQueueUsage: garpQueue usage
has exceeded fifty/eighty/ninety percent
GMRP
GARP/GVRP/
gid_destroy_port: Error Removing port %d
registration for vlan-mac %d -
GMRP
%02X:%02X:%02X:%02X:%02X:%02X
GARP/GVRP/
gmd_create_entry: GMRP failure adding MFDB
entry: vlan %d and address %s
GMRP
Component
Message
802.3ad
dot3adReceiveMachine: received default event
%x
802.3ad
dot3adNimEventCompletionCallback,
dot3adNimEventCreateCompletionCallback:
DOT3AD: notification failed for event(%d),
intf(%d), reason(%d)
Component
Message
FDB
fdbSetAddressAgingTimeOut: Failure setting fid
%d address aging timeout to %d
Component
Message
Double Vlan Tag
dvlantagIntfIsConfigurable: Error accessing
dvlantag config data for interface %d
© 2009 D-Link Corporation. All Rights Reserved
530
Table 34: GARP/GVRP/GMRP Log Messages
Table 35: 802.3ad Log Messages
Table 36: FDB Log Message
Table 37: Double VLAN Tag Log Message
Cause
The garpQueue is full, logs specifics of the
message content like internal interface number,
type of message, etc.
The garpPduQueue is full, logs specific of the
GPDU, internal interface number, vlan id, buffer
handle, etc.
A default configuration does not exist for this
interface. Typically a case when a new interface is
created and has no pre-configuration.
Traces the build up of message queue. Helpful in
determining the load on GARP.
Mismatch between the gmd (gmrp database) and
MFDB.
MFDB table is full.
Cause
Received a LAG PDU and the RX state machine is
ignoring this LAGPDU.
The event sent to NIM was not completed
successfully.
Cause
Unable to set the age time in the hardware.
Cause
A default configuration does not exist for this
interface. Typically a case when a new interface is
created and has no pre-configuration.