User Account Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Term Definition
Session Time Total time this session has been connected.
Session Type Shows the type of session, which can be HTTP, HTTPS, telnet, serial, or SSH.
U A
SER CCOUNT
This section describes the commands you use to add, manage, and delete system users. Unified Switch software has two
default users: admin and guest. The admin user can view and configure system settings, and the guest user can view
settings.
Note: You cannot delete the admin user. There is only one user allowed with read/write privileges. You can
configure up to five read-only users on the system.
users name
This command adds a new user account, if space permits. The account <username> can be up to eight characters in length.
You can use alphanumeric characters as well as the dash (-) and underscore (_). You can define up to six user names.
Note: The <username> is not case sensitive when you add and delete users, and when the user logs in.
However, when you use the <username> to set the user password, authentication, or encryption, you must enter
the <username> in the same case you used when you added the user. To see the case of the <username>,
enter the show users command.
Format
users name <username>
Mode Global Config
no users name
This command removes a user account.
Format
no users name <username>
Mode Global Config
Note: You cannot delete the "admin" user account.
users name unlock
Use this command to unlock a locked user account. Only a user with read/write access can re-activate a locked user
account.
Format
users name <username> unlock
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
490
C
OMMANDS