Radius Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
RADIUS C
OMMANDS
This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In User Service
(RADIUS) server on your network for authentication and accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
Default disable
Format
authorization network radius
Mode Global Config
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
Format
no authorization network radius
Mode Global Config
radius accounting mode
This command is used to enable the RADIUS accounting function on the Unified Switch.
Default disabled
Format
radius accounting mode
Mode Global Config
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS accounting function is
disabled.
Format
no radius accounting mode
Mode Global Config
radius server attribute
This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS requests. If the specific IP
address is configured while enabling this attribute, the RADIUS client uses that IP address while sending NAS-IP-Address
attribute in RADIUS communication.
Format
radius server attribute <4> [<ipaddr>]
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
504