Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no lldp transmit-mgmt
Use this command to include transmission of the local system management address information in the LLDPDUs. Use this
command to cancel inclusion of the management information in LLDPDUs.
Format
no lldp transmit-mgmt
Mode
Interface Config
lldp notification
Use this command to enable remote data change notifications.
Default
disabled
Format
lldp notification
Mode
Interface Config
no lldp notification
Use this command to disable notifications.
Default
disabled
Format
no lldp notification
Mode
Interface Config
lldp notification-interval
Use this command to configure how frequently the system sends remote data change notifications. The <interval>
parameter is the number of seconds to wait between sending notifications. The valid interval range is 5-3600 seconds.
Default
5
Format
lldp notification-interval <interval>
Mode
Global Config
no lldp notification-interval
Use this command to return the notification interval to the default value.
Format
no lldp notification-interval
Mode
Global Config
clear lldp statistics
Use this command to reset all LLDP statistics, including MED-related information.
Format
clear lldp statistics
Mode
Privileged Exec
© 2009 D-Link Corporation. All Rights Reserved
134
Advertisement
Table of Contents
