D-Link DWS-4000 Series Cli Command Reference page 360

D-Link Unified Switch CLI Command Reference
protocol
This command configures the protocol mode for a captive portal configuration. The CP can use HTTP or HTTPS protocols.
Default https
Format
protocol {http | https}
Mode Captive Portal Instance
verification
This command configures the verification mode for a captive portal configuration. The type of user verification to perform can
be one of the following:
• Guest: The user does not need to be authenticated by a database.
• Local: The switch uses a local database to authenticated users.
• RADIUS: The switch uses a database on a remote RADIUS server to authenticate users.
Default guest
Format
verification {guest | local | radius}
Mode Captive Portal Instance
group
This command assigns a group ID to a captive portal configuration. Each Captive Portal configuration must contain at least
one group ID. The group-ID has a 1-1024 range. Group ID 1 is the default.
Default group-ID 1
Format
group <group-ID>
Mode Captive Portal Instance
radius-accounting
This command enables accounting for a captive portal configuration.
Default Disable
Format
radius accounting
Mode Captive Portal Instance
no radius-auth-server
This command disables accounting for a captive portal configuration.
Format
no radius accounting
Mode Captive Portal Instance
radius-auth-server
Use this command to configure a captive portal configuration RADIUS authentication server.
© 2009 D-Link Corporation. All Rights Reserved
352