Detected Clients Database Commands - D-Link DWS-4000 Series Cli Command Reference

D C
ETECTED LIENTS
This section provides status and configuration commands for the detected client database.
wids-security client rogue-det-trap-interval
Use this command to set the interval in seconds between transmissions of the trap telling you that rogue clients are present
in the Detected Clients Database.
Default 60
Format
wids-security client rogue-det-trap-interval <0-3600>
Mode Wireless Config
Parameter Description
0-3600 Interval in seconds between transmissions of the trap. The range is 0-3600 seconds. A configured
value of 0 disables the trap from being sent.
no wids-security client rogue-det-trap-interval
Use this command to restore the rogue detection trap interval to its default value, 60.
Format
no wids-security client rogue-det-trap-interval
Mode Wireless Config
Example: The following shows an example of the command.
(DWS-4026) # wids-security client rogue-det-trap-interval 60
<cr> Press Enter to execute the command.
(DWS-4026) # no wids-security client rogue-det-trap-interval ?
<cr> Press Enter to execute the command.
wids-security client known-client-database
Use this command to enable the test which marks the client as a rogue if it is not in the Known Clients database.
Default Disable
Format
wids-security client known-client-database
Mode Wireless Config
no wids-security client known-client-database
Use this command to disable the check for the client in the Known Clients database.
Format
no wids-security client known-client-database
Mode Wireless Config
D C
ATABASE OMMANDS

Detected Clients Database Commands

?
331